Although a bandsaw can appear to be a safe machine, a running bandsaw can
cause considerable injury.
Although care was taken in the design of this bandsaw, no two shop built bandsaws
will be strictly identical.
It is assumed that the builder is skilled
in woodworking. This should not be your first woodworking project.
It is also assumed that the builder is already familiar with the safe
operation of bandsaws.
Woodgears.ca cannot be held liable for injuries
that you may incur with your bandsaw.
Some safety tips
Other than the usual risk of cutting into your fingers, another possibility
of injury with this bandsaw is that the incomplete bandsaw may tip over, especially
while it's running. The bandsaw, without the lower enclosure in place is
somewhat tippy, and it is advisable to clamp it down or clamp some boards to the stand
to prevent it from tipping over.
When installing a blade, always turn the wheels for a few turns manually until
the blade has settled in a particular position before turning on the motor.
If you are unsure the first time you put a blade on the bandsaw, it may be advisable
to put the blade on the saw backwards, that is, with the teeth facing the saw,
not the operator. Move the blade guides out of the way before doing this.
When milling logs or resawing wide boards, it's best to cut the last 2 cm of wood
by pulling the wood through the saw instead of pushing. That way you won't accidentally
push your hands into the blade.